Institutional: From spilled water coolers to full flood damage X-Cide Mold will counter that mildew and wet carpet smell while your fans and dehumidifiers go to work drying the environment out.
The Vapor Concentrate gives you total control over the amount of vapor released and the length of time your concentrate will last.
The Vapor Tunnel is designed to treat up to a 20,000 cu. ft. area. The tunnel can be placed on any flat surface or attached to the wall with simple Velcro tape. The Vapor Concentrate Squares/Bars are placed into the Tunnel by sliding one of the supply trays out and pressing the Square onto the pins.
For a controlled release of vapor you will leave the plastic wrap of the Vapor Concentrate Square/Bar in place. You will cut a slit in the top of the wrap to allow the vapor to escape at a controlled rate. The longer the slit the more vapor is released and the faster the vapor concentrate is used up. The shorter the slit the less the vapor is released and the longer the vapor concentrate will last.
The vapor release from a Vapor Square or Bar will begin to decline after approximately about 350 hrs. Although the vapor production begins to decline the production will continue for over 500 hrs. So as more vapor is needed add an additional square or bar but leave the existing one in place to contribute vapor until it is completely exhausted.
For very high concentrations of vapor for short periods of time (up to 150 hrs.) remove the plastic wrap from the Vapor Square/Bar completely.
When the Vapor Concentrate is not in use place it in a sealed plastic bag to preserve it.